Publicidad
Idiomas disponibles
Idiomas disponibles
Setting up the device
Setting up the device
Electric shock may occur due to a humid environment.
Do not set up the device outdoors or in humid rooms.
Fire may occur due to overheated components.
When setting up the device, observe the minimum distances
specified in this manual.
Protect the device from naked flames or hot surfaces.
Protect the device from direct sunlight.
Set up the device ensuring that the mains plug is accessible.
Place the device on a sufficiently stable surface. Make sure that there is
a gap of at least 20 cm from the back wall and at least 3 cm to the nea-
rest wall at the sides.
Leave a space for an opening angle of 160° for the door of the device.
Device start-up
Clean the device thoroughly before using for the first time (see p. 106).
Connect the device to the power supply (see p. 104).
After moving the device, leave it upright for 24 hours before switching
it on again. If you have moved the device, wait 30 minutes before
switching it on.
Connecting and disconnecting the mains cable
Insert the mains plug into a properly installed socket.
The device is switched on.
104
WARNING
WARNING
Publicidad
