Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly of the dashboard on handle
•
Remove the plastic dashboard from the packaging carefully.
•
Place the dashboard on upper handle, matching the corresponding holes (points 1, 2, 3, 4
picture)
•
Clip now the dashboard on the handle and check it is secure.
E- Cutting height adjustment
The cutting height adjustment lever is situated above the right rear wheel.
To adjust the cutting height, pull the height adjustment lever out and away from the lawnmower and move
forward or backwards into another slot depending whether you want it to cut shorter (low position of lever) or
longer (high position of lever) on some models or vice versa cut shorter (high position of lever) or cut longer
(low position of lever): it depends on mower models (as indicate here below).
NOTE
For rough and uneven lawns, move the height adjuster to a higher position as this will stop scalping.
–
see below
Publicidad
