Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
11. Insert the Universal Wall Clip (DD) into both
sides of the 26-IN Vertical Standards (A) near its
center point. Once inserted push clips up and
mark the hardware hole locations.
Hardware Used
Universal Wall
DD
Clip
NOTE:
Ensure Universal Wall Clip is installed in upward
direction for maximum support.
12. Remove Universal Wall Clip (DD) and using
5/16" drill bit, pre-drill marked hole locations into
drywall. Do not drill through the metal brackets.
If you are unsure if a stud is located
PRO TIP
behind markings, use 1/8" drill bit to
drill all holes. If no stud is present,
then use 5/16" drill bit to make holes
larger for drywall anchors.
11
x 2
12
11
Publicidad
