Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
3. With the Extender Bracket (FF) installed, mark
the hardware hole location.
4. Remove the Extender Bracket (FF) and using
5/16" drill bit, pre-drill marked hole locations into
drywall. Then install Drywall Anchor (AA) into
pre-drilled drywall holes. Do not drill through the
metal bracket.
Hardware Used
AA
Drywall Anchor
If you are unsure if a stud is located
PRO TIP
behind markings, use 1/8" drill bit to
drill all holes. If no stud is present,
then use 5/16" drill bit to make holes
larger for drywall anchors.
Use a rubber mallet to lightly tap
PRO TIP
Drywall Anchors (AA) into the drywall.
3
4
x 1
7
FF
AA
Publicidad
