Descargar Imprimir esta página

Bogner BDECM02 Manual De Usuario página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
Before use:
1. Pour the water into the tank. The water level should not exceed the "Max"
mark in the tank. Your appliance was designed to operate only with cold
or room temperature water.
2. Connect the power cord, then press the "
light on the screen is flashing (as shown by the arrow on the picture
below) and the other indicator lights are off. Turn on the "steam knob"
and water will come out. Turn off the "steam knob".
Note:
a. If the ON/OFF indicator light does not light up, then turn the steam knob
clockwise.
b. When water comes out of the coffee machine, the internal pump will make
a working vibration sound.
3.The machine starts to preheat and the indicator light on the screen is
flashing (as shown by the arrow on the picture below). When the indicator
light stops flashing and lights up, the preheating is finished. This process
takes about 2 minutes.
7
" button. The indicator
4.Press the "
" button and the corresponding indicator light on the
screen will start flashing (as shown by the arrow on the picture below).
Let hot water come out to clean the filter or coffee cup. After cleaning,
press the button again to stop the water flow.
5. During preheating, put the ground coffee powder (it should not be too
thick or too fine) into the metal filter, then use the measuring spoon to
compress and flatten it. Clean the extra coffee powder from the edge of
the filter with your hand or brushes.
6.Insert the funnel and lock it (follow the mark) and put the coffee cup
under the funnel.
7.When the indicator light remains light up (as shown by the arrow on the
picture below), press the "
" button and coffee will begin to flow. At
the same time, adjust the position of the coffee cup to let the coffee flow
into the cup along the cup's wall. When the desired amount is reached,
press the "
" button again to stop the flow of coffee.
Operation
8

Publicidad

loading