BOMANN WK 5024 CB Instrucciones De Servicio página 29

CAUTION:
Do not immerse the device into water for cleaning.
• Please follow the instructions as stipulated in the chapter "Cleaning".
Instructions
Preparation
Before using for the first time, boil fresh water at least three
times in the appliance. Use only water without any additives or
ingredients.
Electrical connection
Check whether the electrical voltage that you intend to use is
the same as that of the machine. Details are to be found on the
label on the base.
CAUTION: Overload!
Do not use any multiple sockets, as this device is too power-
ful.
Switching on/off
Switching on: Press the toggle switch downwards. The indica-
tor light in the switch lights up.
Switching off: Press the toggle switch upwards. The indicator
light in the switch goes off.
Use
NOTE:
• Always use fresh water.
• Do not consume the water if it has been in the kettle for
more than one hour.
• Also do not constantly reheat cooled water.
• Always pour out stagnant water.
1. Place the machine on a flat surface.
2. Press the button in the handle to open the kettle.
WARNING:
• Always turn the device off before cleaning it and remove the mains
plug. Wait until the device has cooled down.
• Never immerse the device or the base in water or other liquids.
CAUTION
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
3. Then fill in the water (max 1.0 Litre). You can read the filling
level on the water level indicator of the kettle.
4. Close the lid.
5. Place the kettle flush on the base.
6. Only connect the machine to a properly installed safety
socket.
7. Switch on the kettle by pressing the switch. The control
lamp in the switch will light up.
Pausing / terminating operation
There are two options to interrupt the boiling process or to
terminate it:
• The appliance will shut off automatically after the boiling
process. The indicator lamp will go out.
• Set the switch to the "0" position to pause or terminate the
boiling process.
WARNING:
• Do not remove the appliance from the base without shut-
ting it off first. As long as the switch is in the "I" position,
the kettle will stay turned on.
• Always shut off the appliance before removing it from the
base! Also ensure that it is turned off when you set it back
onto the base!
WARNING: Danger of scalding!
• When pouring the water out, keep the lid closed.
• During operation the housing becomes hot. Do not touch
it and allow the device to cool down before storing it
away.
• Disconnect the power cord.
• Emptying the water container.
Cleaning
• Rinse the water container out with clean water. Then dry it
off with a cloth.
• Clean the housing after use with a slightly damp cloth.
29