Publicidad
Idiomas disponibles
Idiomas disponibles
Note: a screwdriver (not included) is a tool for assemblying the unit.
Place of installation:
•
The door, guide, actuator and controller should be mounted on the inside
wall of the hen house, and the light sensor should be led outside through a
suitable hole.
The ambient temperature should not fall below -18°C.
•
Assembly
1)
Cut an entrance of 22x32 cm (width x height) in the wall of the poultry house.
Leave a 2.5 cm gap between the floor and the opening.
2)
Install the guides on both sides of the door opening (during installation, it is
recommended to slide the door into the guides for a moment to make sure
that the distance between the guides is adequate). The screw holes should
be on the outer edges of the guides. The guides should protrude below the
door opening.
3)
Install the screw [D] in the hole in the door. Tighten securely with the flange
nut [C]. Slide the door into the guides with the screw thread facing away
from the wall.
Publicidad
