General Operation; Start-Up Test And Adjustment; Start; Stop - DST DC-10 Manual Del Usuario

5 OPERATION

5.1 GENERAL OPERATION

The mode switch has two operation modes.
• Manual (MAN
• Automatic (AUTO
resumes operation when the measured value is above the control setpoint. A humidistat* is required to operate the unit in automatic-mode. Additional settings are
available in auto-mode.
Attention!
• AUTO-VENT
• AUTO-OFF
Caution!
5.2
1. Inspect and clean the inside of the unit from foreign objects such as rags, tools, particles of metal, and such, that may pose damage to the inside of the unit.
2. If any, ensure that both air balance dampers are open and check that the air paths of the duct work are not obstructed in any way.
3.
4. Check and, if needed, reduce the electrical consumption to the recommended . See
5. If applicable, check that the rating of the electrical supply fuses is correct, see wiring diagram.

5.3 START

1. Switch MAN/AUTO [5] to "MAN" (AUTO-mode can only be used if a humidistat is connected).
2. Switch ON/OFF [2] to "ON".
3.

5.4 STOP

1. Switch ON/OFF [2] to "OFF".
1. Ammeter (only displays the heater current)*
2. ON/OFF
3. Electrical cable
4. Elapsed time meter*
5. MAN/AUTO
6. Humidistat plug
DC-10 EN.05
and see heater current in
1
2
3
13
EN
.
4
5
6
Seibu Giken DST