Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
1. Using the 3/8" drill bit, drill 4 holes and install
the 4 plastic anchors provided. See fig 1.
2. Using the 3/8" wrench screw 2 of the mounting
screws into the lower left and upper right,
leaving about 6 mm (1/4-in) between the wall
and screw head.
3. Hang the hose reel on these 2 screws. Slide
down the screw slid onto the small end of holes
on the base plate (D). See fig 2.
4. Tightly tighten the 2 screws to the mounting
bracket. See fig 2.
5. Install and tighten down the 2 remaining
screws. See fig 3.
6. Wrap 3-5 layers of sealant tape on both male
plug ends of the leader hose (C). Screw one
end into the air inlet (E). Use a 9/16" (14mm)
wrench to tighten together. See fig 4.
1
AA
BB
2
3
4
6
D
BB
E
C
Publicidad
