Descargar Imprimir esta página

LF Kobalt SGY-AIR266 Manual Del Usuario página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY INSTRUCTIONS
7. Depending on your setup you can either attach
a female inlet plug or a female quick
disconnect to the other end of the leader hose.
See fig 5.
8. Pull out the hose to the desired length (ensure
the hose reel is locked as it will not rewind),
open the latch on the bumper (H) and move it
to the desired location. Re-latch the
bumper (H). See fig 6.
9. The roller bracket (I) can be adjusted to the
best angle/position for the smoothest
operation of hose reel (A) when the hose reel
is mounted. Loosen three screws (J) on each
side with 5/16 (5mm) allen Wrench, rotate the
roller bracket (I) to the desired position, then
tightly tighten the three screws (J) on each
side. See fig 7.
NOTE
If the desire angle is larger than 90
degrees, take off 3 screws (J) on each side,
rotate the roller bracket to the desire position,
and reassemble and tighten the 3 screws.
WARNING
When loosening or removing the screws (J) on each side be careful that
the hose reel does not spin freely and cause the hose reel to lose tension.
5
6
7
7
H
I
J

Publicidad

loading

Este manual también es adecuado para:

5091975