Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly. The table includes some of the most common
problems, their causes and remedies.
WARNING! When the following anomalies occur in the air conditioning system, switch it off and remove
the plug. Then contact the Official Technical Service.
PROBLEM
Check that the power connection is properly
The air
made.
conditioning is
Check if the water level indicator lights up.
not working
Check the room temperature.
Check that the air filter is not dirty.
Check if the air line is blocked.
Works with a
Check if the room's door or window is open.
reduced capacity
Check if the desired operating mode has been
selected and if the temperature is correctly set.
The exhaust hose is disconnected.
Overflow while moving the unit.
Water leakage
Check if the drain hose is bent or kinked.
Check if the unit is correctly positioned.
Excessive noise
Check if there are any loose and vibrating parts.
The noise sounds like water flowing.
TABLE OF ERRORS
DETECTION CODES
E0
E1
E2
FT
Mc HAUS
CAUSE
Communication failure between main PCB and display PCB.
Ambient temperature sensor failure.
Coil temperature sensor failure.
High level of condensed water. Empty the drain pan by removing the plug.
artic-12
SOLUTION
Insert the power cord securely into the wall
outlet.
Empty the drainage tray by removing the
rubber stopper.
The operating temperature range is 5-35°C.
Clean the air filter as needed.
To clear the obstacle.
Keep the door and windows closed.
Set the mode and temperature to the proper
set point according to the manual.
Make sure the exhaust hose is securely
attached.
Empty the water tank before transport.
Straighten the hose to avoid a trap.
Place the unit in a horizontal and firm
position.
Secure and tighten the parts.
The noise comes from the flowing coolant.
This is normal.
MEANING
Publicidad
