Spring 95 Serie Instrucciones De Uso página 7

El-Heizelemente 8.12.2005
Using the Chafing Dish
1. Fill the water pan with 1,5 cm oder bis zur Markierung of hot water (50° to 60° C). Please note that the pans
should not be immersed in the water!
Check the water level now and then. The pan must never be used without water!
2. Close the lid.
3. Plug in the cord of the electric heating unit. Then wait 30 to 40 minutes for the chafing dish to reach the per-
fect temperature.
CAUTION: Never use the electric heating unit when it is not inserted in the water pan!
NOTE: With electric heating units that have a power control the maximum power can be progressi-
vely reduced if required. Position «9» = maximum · Position «1» = minimum · Position «0» = off
Disassembly
1. Unplug the cord.
2. Wait until the water pan and the electric heating unit have cooled down.
3. Take the water pan out of the stand and turn it upside down.
4. Unscrew hand nuts by hand.
5. Slide the heating unit out of the elongated perforations and lift it off the threaded studs.
Cleaning
1. Unplug the cord.
2. Wait until the water pan and the electric heating unit have cooled down.
3. Take the heating unit off the water pan as indicated in «Disassembly».
4. Clean it with a sightly damp cloth.
CAUTION: Do not submerge the heating unit in water or rinse it under running water! (4)
Transportation
Please always unplug the cord before you move your chafing dish or beverage dispenser!
Possible Faults and their Cause
Food cools off and is not kept warm.
– The water pan was filled with cold water.
– Preheating time too short or no preheating.
– Heating unit was not correctly tightened.
– Fill water pan with hot water.
– Preheat unit for 30 to 40 minutes.
– Tighten heating unit by hand.
– Turn power control up.
Great heat loss.
– Lid remains open.
– Keep lid closed whenever possible:
– To prevent food from drying out.
– To guarantee more hygienic conditions.
– To save energy.
Repairs
The heating unit is completely sealed, therefore it cannot be repaired.
Exception: The connection cord is connected to the black terminal box located at the front of the unit. Only an
expert electrician may change the connection cord.
Warranty
Spring provides one (1) year guarantee on all heating units, unless that the damage is not due to improper handling
and/or repairs. For details please refer to the «General Conditions of Sale and Delivery».
10:00 Uhr Seite 7
E
7