DEXIS 14014550 Manual Del Usuario página 22

DEXIS
4. From the USB drive, right click on DEXIS_IO_Sensor_Driver_
Setup_Launcher.exe and select Run As Administrator.
The Software Manager is ready to install the latest version of your
Imaging Software, the DEXIS Legacy IO Sensor Drivers (if not previ-
ously installed) and DEXIS IO Sensor Drivers.
5. The Software Manager begins
installing the software.
6. Accept End User License
Agreement.
7. Select the Typical option to
install the standard feature set.
8. Verify that your Imaging
Software and DEXIS IO
Sensor Drivers were success-
fully installed by viewing the
Software Manager.
9. Reboot your computer to
complete the software instal-
lation for your new DEXIS
sensor
NOTE: The calibration of the sensor is initiated when a patient is launched in
DEXIS 9 and when IO acquisition is launched in DEXIS 10. This is not
needed for VixWin/GxPicture, as calibration begins automatically when
the sensor is connected.
4-2 English