STAR Water Systems SPCP02 Manual Del Usuario página 6

UTILITY PUMP INSTALLATION INSTRUCTIONS
1. To enable pump to fit into smaller spaces
remove snap on base from pump by pulling the
tab outward. This allows the pump to lift out of
the base.
2. Attach garden hose adapter to the pump
discharge and then connect garden hose
to adapter. DO NOT OVER-TIGHTEN THE
GARDEN HOSE OR HOSE ADAPTER. Finger
tight plus 1/4 to 1/2 turn should be sufficient.
Attach cap to bottom outlet.
3. Place pump in the water on a hard surface.
Water must be at least 1-3/4-in deep in order for
pump to operate. Avoid placing pump directly on
sand, dirt, or mud.
1
2
3
6
Hard
Surface