TruVision TVN 12 Guia De Inicio Rapido página 7

Note: If adding cameras to the recorder that
have a different password than the camera
password in the recorder, select the
Password function and click Save.
Using the LAN network
This method can be used for all recorder
models.
For recorders with PoE ports: make sure
that one or more of the PoE ports on the
recorder is disabled so that cameras that are
on the LAN can be added to the recorder. You
can do this via the OSD or via the webpage.
Via the webpage:
To see which cameras are connected to a
PoE port, click Configuration
Camera Management
The list of cameras appears showing which
are connected to a PoE port. Click
save any changes made.
Via the OSD menu:
To see which cameras are connected to a
PoE port, click Configuration
Camera > PoE Binding. Click
any changes made.
 Camera is not yet activated:
Note: If a camera is not activated, its default
IP address is 192.168.1.70.
The camera can only be activated
successfully in web mode (described below) if
the recorder's IP address is within the same
network segment of the default IP address of
the camera.
When the recorder has an IP address in
another network range, you must activate the
IP camera first via the TruVision Device
Manager or follow the process in OSD mode.
TVN 12 Quick Start Guide
Sync.IPC
> System >
PoE Binding.
>
Save to
> Camera >
Apply to save
To add an IP camera on the LAN network in
web mode:
1. Click Configuration
Management
>
Quick Add
2. Click
the LAN. Select the desired camera and
click OK.
3. Select the camera from the list and click
Activation. You will be asked to enter a
camera password, or you can select to use
the default IP camera password that you
added in the recorder and click
the section "Manage camera passwords" in
the user manual for more information).
4. The camera is activated and comes online.
Refresh
Click to refresh the webpage to
see the camera status change from offline
to online.
5. Add another camera by following steps 2 to
4.
To add an IP camera on the LAN in OSD
mode:
Configuration
1. Click
> IP Channel.
2. Click Online Device List
of cameras in the LAN.
3. Select the camera that you want to add
and press Activate
4. The recorder asks you to enter a new
password, or you can select to use the
camera password that is stored in the
recorder.
The camera is activated.
5. Add the camera using the default IP
address (192.168.1.70) to the recorder.
Recommended:
the IP address of the camera before it is
added.
6. Add the camera to the recorder via the
+Add
button.
 Camera is already activated:
To add an IP camera on the LAN network in
web mode:
1. Make sure that the cameras are on the
same network segment as the recorder. If
needed, use the TruVision Device Manager
> System > Camera
IP Camera.
to find the cameras on
OK (see
Camera Camera
> >
to display the list
All.
press Edit IP and change
EN-5