Publicidad
Idiomas disponibles
Idiomas disponibles
USER GUIDE
1.
Find your vehicle's make, model, and year in the COMPATIBILITY LOOKUP
on page 3. Turn the dial on the EZ Installer to the position listed for your
vehicle's make, model, and year.
NOTE: One working key should be present during the pairing process.
2.
Begin with the vehicle in PARK and the engine OFF.
3.
Enter the vehicle and close all doors.
4.
Insert the key into the ignition and turn the key to the ON position. This
should be the position before starting the vehicle, see below. DO NOT start
the vehicle
5.
Remove the security label from the EZ Installer and insert it firmly into
the on-board diagnostic (OBD) port located under the dash.
a. The location of your vehicle's OBD port can be found in the
owner's manual.
6.
The EZ Installer will beep twice when it powers up and starts the process.
7.
The EZ Installer will sound a short tune when programming mode has
started.
a. Your vehicle may or may not provide feedback such as the door
lock cycling, a message on the dashboard, or a chime.
8.
After hearing this short tune, press and hold both Lock and Unlock on your
new remote for approximately 15 seconds.
9.
Repeat step 8 for each additional remote to be programmed.
10.
After all remotes have been added, turn the key to the Off position and
unplug the EZ Installer.
11.
Press buttons on each remote to test they were properly programmed to
the vehicle.*
*Some vehicles may need to have the engine started and stopped, and the
driver's door opened and closed before the remotes will work.
FREQUENTLY ASKED QUESTIONS
Q: Can I use the same EZ Installer on other vehicles?
4
GM IGNITION POSITIONS
USER GUIDE
A: No. The EZ Installer will be locked to the first vehicle it is used on.
You may add more remotes to the same vehicle again as needed, but it
will not work on different vehicles. If the EZ Installer sounds 3 beeps at
1 second intervals, and then beeps rapidly, this signifies the device has
already been used on another vehicle. Visit CKESimpleKey.com or your
local retailer to purchase additional remotes.
Q: The new remote won't pair to my car. What should I do?
A: If the EZ Installer doesn't pair the remote to your car, most likely,
an incorrect dial position was used. In this case, the EZ Installer will
beep continuously after you press the pairing button. Check the
compatibility section on page 3 to confirm the correct dial position
for your make, model, year, and button configuration of your original
remote. Remove the EZ Installer, turn the Ignition off and try the
pairing process from step 1. If the remote still won't pair, please contact
customer service at (888) 598-8910.
Q: The EZ Installer was unplugged during the pairing process. What
should I do?
A: The EZ Installer must remain plugged into the on-board diagnostic
(OBD) port until pairing is complete. If the EZ Installer becomes
unplugged during the pairing process, turn the ignition to the OFF
position, remove the key, and begin the pairing process again.
FCC REGULATORY STATEMENTS
MODEL: 2AOKM-GV6
47 CFR §15.19(a)(3) THIS DEVICE COMPLIES WITH PART 15 OF
THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS. (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
NOTE: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
5
Publicidad
