Publicidad
Idiomas disponibles
Idiomas disponibles
Models: 1666 • 1840 • 1842 • 1895
Insert the regulator and lPG cylinder into the gas line of the
STEP 02
appliance� Turn the collar of the regulator clockwise to secure it to
the gas line�
LEAK TEST INSTRUCTIONS
NOTICE
DO NOT use household cleaning agents. Damage to gas valve
and regulator components may result.
Use a clean paintbrush and a 10/90 mild soap and water
solution to perform the leak test.
Turn the control knobs to oFF�
STEP 01
Connect the lPG cylinder to the regulator� Connect the
STEP 02
regulator to the appliance�
The regulator may make a humming or whistling noise during operation. This
The regulator may make a humming or whistling noise during operation. This
will not affect safety or use of the appliance.
will not affect safety or use of the appliance.
BLACKSTONEPRODUCTS.COM/SUPPORT
USING YOUR BLACKSTONE
LPG CYLINDER SAFETY
• The lPG supply cylinder to be used must be constructed and
marked in accordance with the specifications for lP gas cylin-
ders, U�s� department of Transportation (doT) or the standard for
Cylinders, spheres and Tubes for the Transportation of dangerous
Goods, CAN/CsA-B339�
• only lPG cylinders marked "propane" shall be used�
• The cylinder used, if in excess of 2�2 Ib (1�00 kg) propane capacity,
must include a collar to protect the cylinder valve�
• The lPG cylinder supply system must be arranged for vapor
withdrawal�
Always keep new lPG cylinders in upright position during use, transit or
Always keep new lPG cylinders in upright position during use, transit or
storage.
storage.
ensure that the lPG cylinder is positioned below the regulator�
(If the liquid level of the propane is above the regulator, the regulator will frost.)
(If the liquid level of the propane is above the regulator, the regulator will frost.)
IF FROSTING PERSISTS AFTER BOTTLE IS ANGLED CORRECTLY:
Turn off the appliance and disconnect lPG cylinder
STEP 01
immediately�
This indicates a problem with the lPG cylinder and it should not be used on any
This indicates a problem with the lPG cylinder and it should not be used on any
product.
product.
Return lPG cylinder to supplier�
STEP 02
Brush soapy solution
STEP 03
onto joint areas of valves and
regulator�
leaks are indicated by growing
leaks are indicated by growing
bubbles.
bubbles.
If growing bubbles
STEP 04
appear, re-tighten connections�
WARNING
If leaks cannot be stopped,
DO NOT try to repair.
Regulator must be replaced
with a Blackstone approved
model.
| OWNER'S MANUAL
The gas regulator is intended to be
The gas regulator is intended to be
used at an angle towards the rear of
used at an angle towards the rear of
the appliance.
the appliance.
07
Publicidad
