Publicidad
Preparation
Dust extraction hose installation
• Connect thw dust extraction hose to the dust extraction
port of the machine with an internal diameter of 1 3/8" (or
35 mm) (not compatible with Truper brand vacuums).
• Connect the dust extraction hose to a dust extractor or
vacuum cleaner.
Base Plastic Protector
The tool is equipped with a protection for the base plate.
It protects delicate surfaces. To set up hook the protector
up front of the base plate and then press it into the rear
part until hearing a click.
Installation of the Saw Blade
• With the jig saw in an inverted position turn the fast
support (A) counterclockwise. Fully insert the saw blade
into the saw blade slot (B) with the cutting teeth to the
front. Release the support to let the jaw catching the saw
blade.
• Try to move the saw blade to double check it is firmly
secured.
• Double check the saw blade is properly set and it can
easily run in the roller guide slot (C). Otherwise the
balancing action will not work right and the saw blade will
not be supported while cutting.
Start Up and Operation Control
• Intermittent Operation:
Connect the plug into the power outlet.
Press the switch (D) to start the tool.
To stop the tool, simply release the switch.
• Continuous Operation:
Connect the plug into the power outlet.
Press the switch (D) and block it pressing the lock-on
button (E).
To stop the tool, press and release the switch.
This jig saw uses "T" blades.
To gain better cutting results
double check you are using
the saw blade assigned for the
material and cutting quality
you look for.
B
A
E
D
C
The work light turns on
when the switch is pressed.
7
ENGLISH
Publicidad
