TMC Reef Skim Pro 300 Manual De Instrucciones página 7

The Reef Skim Pro unit is designed to be used in-sump only and ideally positioned as close to the aquarium drain pipe
as possible to ensure the best possible pick up of organics and other waste.
To ensure that the collection cup can be easily removed for cleaning,allow at least 50mm clearance above the collection
cup lid.
1. Place the skimmer in the first section ofthe sump,or the section where the aquarium drain pipework is. We
recommend you use mechanical filtration on the end of the drain pipework such as the Aqua Habitats Filter Bag System
(sold separately). This will ensure no large pieces of detritus are sucked into the pump which may damage the impeller
and/or pump.
2. Ensure the skimmer and its parts are not touching the sides of the sump as this may cause vibration noise.
3. Fully open the air adjustment dial and water outlet knob before turning the skimmer on.
1. Make sure all connections are tightly secured.
2. Ensure the collection cup is securely and correctly positioned on the main skimmer body and that the drain plug is in
place or the collection cup drain hose is attached.
3. Turn the water adjustment knob anti-clockwise to lower the water level or clockwise to raise the water level.
4. Turn the air adjustment dial to adjust the amount of air pulled in by the skimmer as required.Fully open will be the
most commonly used position but restricting the air flow slightly can improve air pull and, in turn, intensify microbubble
production.
5. Clean and empty the collection cup regularly, and periodically clean and maintain all other internal parts to ensure the
skimmer works as efficiently as possible.
6. The Reef Skim Pro unit can operate in both shallow anddeep water. However, the optimum water level is marked on
the body.
INSTALLATION
GENERAL OPERATING INSTRUCTIONS
WATER LEVEL ADJUSTMENT DIAL
6
Lower Water Level
Increased Flow
Higher Water Level
Decreased Flow