Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
TO ASSEMBLE WALKER
IMPORTANT:
Never change the height
when the baby is in the walker.
1
•
To open the baby
walker and raise
the tray (Fig. 1a),
and locate the lever
underneath the tray.
• To adjust the height:
Twist the lever, slide
it vertically while
simultaneously
pushing the lever
up to adjust (Fig. 1b).
• Ensure the lever is
locked into place after
adjusting the height
(Fig. 1c).
NOTE: The baby
walker can be used
for 3 different heights.
7
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Fig. 1a
XX
"underside"
Fig. 1b
"underside"
Fig. 1c
SEAT
2
•
If assembly required:
Connect the seat fabric
by inserting the plastic
button pins into the
upper, larger openings.
Then push them firmly
downwards until they
SNAP into position
(Fig. 2a).
NOTE: Push the pins
from the top of the
opening all the way
down to the bottom.
• Locate the (4) straps
on back of the seat
and corresponding
slots on the tray. Insert
each strap into its
corresponding slot
(Fig. 2b).
• From the underside of
the tray pull each strap
completely through each
slot. If needed, flex the
double layer webbing
and pull it out from the
slot on the underside.
The ends of the straps
should lay flat against
the underside of the tray
(Fig. 2c).
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
ASSEMBLY
Fig. 2a
Fig. 2b
"underside"
Fig. 2c
8
Publicidad
