Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO OPERATE YOUR CEILING FAN
IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
WARNING:
Check to see that all connections are tight,
including ground, and that no bare wire is
visible at the wire connectors, except for the
ground wire. Do not operate fan until the
blades are in place. Noise and fan damage
could result.
WARNING:
Do not operate this fan with a variable
(Rheostat) wall controller or dimmer switch.
Doing so could result in damage to the
ceiling fan's remote control unit.
To make fan operational, install 23A/12V battery
(included) in hand-held remote transmitter, with fan
power off. Then follow the remote code setting
process. (If not used for long periods of time, remove
battery to prevent damage to transmitter). Store the
remote away from excessive heat or humidly.
(Figure 3)
NOTE:
The remote unit has 16 different code combinations. To
prevent possible interference from or to other remote
units, simply change the combination code in the
remote and receiver.
NOTE:
Factory default setting is dip switches all up.
Do not use this position.
To set the remote code same positions as the receiver with a
small screwdriver or ball point pen (neither included), slide dip
switches firmly up or down. (Figure 4)
WARNING
To reduce the risk of fire or electrical shock,
this fan should only be used with fan speed
control part No.: KLJSQ 3001, manufactrued
by Huizhou Kunli Electronic Co Ltd
Please call or text 1-833-888-FANS (3267) or email support@altitudefans.com for further assistance.
For illustrative purposes only
Dip Switch
15
MAIN FUSE BOX
Remote
ALTITUDEFANS.COM
Publicidad
