altitude FARMDALE 24 Guía De Uso Y Cuidado página 9

HOW TO ASSEMBLE YOUR CEILING FAN (CONTINUED)
Reinstall the hanger ball on the downrod as follows.
Route the black, white and blue wires through the
hanger ball. Position the pin through the two holes in
the downrod and align the hanger ball so the pin is
captured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin. Securely
tighten the set screw in the hanger ball. A loose set
screw could create fan wobble. (Figure 6)
Cut off excess lead wire approximately 6 to 9 inches
above top of the downrod. Strip insulation off 1/2 inch
from the end of each lead wire. (Figure 7)
CAUTION:
All set screws must be checked, and retightened
where necessary before installation.
Remove one of the two shoulder screws in the
hanger bracket and retain the screw for later. Loosen
the second shoulder screw without fully removing it.
(Figure 8)
Please call or text 1-833-888-FANS (3267) or email support@altitudefans.com for further assistance.
Securely
tighten the set screw
in the hanger ball
Loosen
second screw
without
removing
9
Remove one
screw
and retain
ALTITUDEFANS.COM