Publicidad
Idiomas disponibles
Idiomas disponibles
Recalibration Procedure
1. Note the temperature difference
between the temperature setting and
the thermometer.
2. Remove the thermostat cover.
3. Rotate setting knob clockwise
until you hear switch click.
4. Hold the setting knob firmly and
rotate the set point scale ring
counterclockwise
o'clock position of the ring agrees
with the cover thermometer.
5. The heat from your hand will affect
the diaphragm sensor. Replace
thermostat cover, wait five minutes
and recheck calibration.
1-year limited warranty
Resideo warrants this product, excluding battery, to be free
from defects in workmanship or materials, under normal use
and service, for a period of one (1) year from the date of first
purchase by the original purchaser. If at any time during the
warranty period the product is determined to be defective due
to workmanship or materials, Resideo shall repair or replace it (at Resideo's option).
If the product is defective,
(i) return it, with a bill of sale or other dated proof of purchase, to the place from which you purchased it; or
(ii) call Resideo Customer Care at 1-800-468-1502. Customer Care will make the determination whether the product
should be returned to the following address: Resideo Return Goods, 1985 Douglas Dr. N., Golden Valley, MN 55422,
or whether a replacement product can be sent to you.
This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it is shown by Resideo
that the defect was caused by damage which occurred while the product was in the possession of a consumer.
Resideo's sole responsibility shall be to repair or replace the product within the terms stated above. RESIDEO SHALL
NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL
DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS OR
IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so this limitation may
not apply to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY RESIDEO MAKES ON THIS PRODUCT. THE DURATION OF ANY
IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE, IS HEREBY LIMITED TO THE ONE YEAR DURATION OF THIS WARRANTY. Some states do not allow
limitations on how long an implied warranty lasts, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may have other rights which vary from state to state. If you have
any questions concerning this warranty, please write Resideo Customer Care, 1985 Douglas Dr, Golden Valley, MN
55422 or call 1-800-468-1502.
www.resideo.com
This product is manufactured by Resideo Technologies, Inc.,
Golden Valley, MN, 1-800-468-1502
© 2019 Resideo Technologies, Inc. The Honeywell Home trade-
mark is used under license from Honeywell International Inc.
All rights reserved.
until the 12
Resideo Inc., 1985 Douglas Drive North
Golden Valley, MN 55422
33-00143ES—03 M.S. Rev. 06-19 | Printed in United States
THERMOSTAT
BASE
SETTING KNOB
AT 12 O'CLOCK
POSITION
SCALE RING
SETTING KNOB
33-00143ES-03
M5796A
Publicidad
