Descargar Imprimir esta página

Livoo DOS196 Manual De Instrucciones página 14

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
Use of the device
Charging instructions
For best performance, fully charge the device before use.
Insert the tip of your cable into the device and the USB end into the device of your choice (computer,
adapter, external battery, etc.). If you choose to charge your device via computer, the charging time will
be longer.
With an external battery or mobile phone adapter, charging will take 8 hours. If you want to use your
product with an adapter (not included) instead of the USB cable (fig 17-18), please respect the voltage
and current mentioned on the product (5V, 1A).
When the product is charging the number will increase and the red light will be always on.
99 number light up once the device is fully charged, and red light will go off.
Note : The product may become slightly warm while charging.
Your device cannot be overcharged. However if the product is not going to be used for an extended period
time ( 2-3months), unplug it and store it. Fully recharge it when you would like to use it again.
Adjusting the appliance:
To remove the heads parts check fig 1-2.
When fitting the head of the appliance, push the bottom of the head into the small notch and press until
it clicks into place (fig. 3-4).
To attach the
full-size
trimmer, do the same until it is locked to the unit (fig. 5-6). There are four positioning
combs with four levels as below:
Level
Length (mm)
1
1
3
2
2
6
3
3
9
4
4
12
Remove the
full size trimmer
Remove the shaving head by pushing it forward (fig 9).
Attach the shaving head by pushing it into the small notch and press until it clicks into place (fig 10).
Note:
Always attach the comb BEFORE switching on the beard trimmer and ensure that the beard trimmer
is switched off when putting or removing the comb attachment.
Adjusting precision trimmer comb:
Attach the precision trimmer by inserting it into the small notch and pressing until it clicks into place (fig.
13).
Level
1
1
2
2
3
3
4
4
Choose different 4 levels positions for precision trimmer positioning comb from up and down (fig 14).
Put body trimmer positioning comb with 3 levels attachments balancely by sliding downwards (fig11).
Level
1
1
2
2
3
3
by pushing it forward ( fig 7-8)
Length (mm)
2
3.5
5
6
Length (mm)
2.8
5.8
9.8
www.livoo.fr
EN

Publicidad

loading