Frigidaire ALLREFKIT Instrucciones De Instalación página 3

4. Attach brackets (H) to the angled end of each side trim (B and
C). Gently secure brackets to side trim by tightening set screws
(I), only until snug to avoid dimpling the extrusion face. See
Figure 4.
DO NOT OVERTIGHTEN.
5. Join each side trim (B and C) to the top trim (A). Make sure the
ends of the Grille Assembly are captured in the channel of each
side trim, then tape in place. Gently secure brackets (H) to top
trim (A) by tightening set screws (I), only until snug to avoid
dimpling the trim face. See Figure 5.
DO NOT OVERTIGHTEN.
Installing Trim & Grille Assembly Into Cabinetry
1. First, place protective covering where side trim will contact the floor near rough opening. Then, stand up
the grille and frame assembly and center in rough opening. See Figure 6. You may need to use several
pieces of tape at the top corners and top center to temporarily hold the assembly in place.
3
H
B
I