Publicidad
Idiomas disponibles
Idiomas disponibles
3. Remove the black plastic top hinge cover and
replace with the silver hinge cover (J).
4. Remove toe grille panel at bottom of the unit.
Save the two screws as they will be used later in
the installation.
5. Place a carpenter's level across the top of the door.
Using a tape measure, adjust leveling feet so that
each door is level and to a height of 65-5/16"
across top front edge of door. See Figure 10.
6. Place a carpenter's level vertically on the front of the
door and level so that front surface of door is vertical.
Re-check to make sure top front edge of door is still
at a height of 65-5/16". Adjust as necessary. See
Figure 11.
7. Plug the power cord into the electrical outlet and slide
unit into place. Recheck the level of your unit.
Depending of the flatness of your floor, you may need
to remove the unit and readjust several times
before achieving an acceptable state of levelness and
alignment.
8. Attach metal toe grille (F) using the two screws saved during removal of the plastic grille panel in Step
4. It may help to open doors of both units to aid alignment of screws. Run screws through the holes on
the right and left side of the toe grill and tighten until slightly snug. Adjust so the top of toe grille is parallel
with the bottom of the door and then tighten both screws. See Figure 12.
Care & Cleaning of Your Trim Kit
The trim and grille kit surfaces are best cleaned with a cotton cloth dampened with a mixture of water and
mild detergent. Avoid abrasive cleansers as they will mar the surface of the metal components.
Figure 12
5
Publicidad
