Preset; In Order To Watch Tv Properly - Premier TV-3704TFT Manual De Instrucciones

7.5. PRESET

POSITION, REMEMBER, BAND, SWAP, FINE, SEARCH and AUTO-SEARCH w ill displa y on
the screen as below description:
7.5.1.Press or
7.5.2.Press or
be displayed when selected. When REMEMBER is OFF, this channel will not be displayed.
7.5.3. Press or
7.5.4. Press or
MENU to confirm SWAP.
7.5.5. Press or
7.5.6. Press or
backward.TV searching indicater bar will turn to green from red after search TV signal.
TV storage system will identify as no signal if TV channel are on too weak signal.
7.5.7. Press or
channel 0 in turns of V-L , V-H and UHF. Station of sufficient strength will be memorized and
searching stops.
7.6. PRESET
POSITION, REMEMBER, ANTENNA, and AUTO-SEARCH will display on the
screen as below description:
7.6.1..Press or
channel will be displayed when selected. When REMEMBER is OFF, this channel
will not be displayed.
7.6.2.Press or
CATV-HRC, CATV-IRC".
7.6.3.Press or
of sufficient strength will be memorized and searching stops.

8. In order to watch TV properly

1 .Set the desired OSD language by pressing LANG.
2. Ensure the COLOR-SYS is correct by checking from SYSTEM menu.
3. Select AUTO-SEARCH in PRESET menu, and start auto search TV signal.
4. Adjust the length, angle and direction of the telescopic antenna to obtain optimum im age.
Notice:
In case the signal intensity is too weak, the image will remain inferior whatever you adjust
the antenna, and cause loud noise wave, shaking image and inferior sound, etc., which is
not TV fault. If the image remains inferior when using telescopic antenna, please try to use
the external antenna or CATV.
to select POSITION, and press
to select REMEMBER, and press
to select BAND ,and then press
to select SWAP, then press
to select FINE. Then press
to select SEARCH. Then press
to select AUTO-SEARCH. Press
to select REMEMBER, and press
to select "ANTENNA" :Press
to select AUTO-SEARCH: Press
or to set.
or to select ON, this channel will
or to switch of V-L,V-H and U.
or to select the channel No. Press
or to adjust channel frenquency by little.
or to start searching forthward or
or to start auto searching from
or to select ON, this
or to select "AIR, CATV-STD,
or to start auto searching. Station
P-7