Quick SMART CHC Manual De Instalacion Y Uso página 21

SMART CHC
4.0 - CONFIGURATION
4.3 - Parameters
UNIT OF MEASURE
Select the unit of measure for the
displayed value (default: meters).
NUMBER OF MAGNETS
Enter the number of magnets present on
the gypsy being used (default: 1).
AUTO FREE FALL
WARNING: only activate this function
is using a windlass equipped with an
auto free fall system.
Select the ON button and set the time that
the windlass uses to lock the gypsy again
after a free fall.
4.4 - Measuring the circumference of the gypsy
To determine the chain development length that is obtained with each rotation of the gypsy, proceed as follows:
1
x
REFERENCE
ON THE GYPSY
REFERENCE
ON THE CHAIN
REFERENCE
ON THE GYPSY
GYPSY LAP
INSTALLATION AND USE MANUAL - REV 001A
SET UP
BACKLIGHT
meter
feet
300
mm
GYPSY CIRCUMFERENCE
2
NUMBER OF MAGNETS
5.0
sec
ON OFF
AUTO FREE FALL
SEND
• Make a mark on the chain and gypsy near the
• Make the gypsy perform one complete turn,
• Measure the length of the chain between
The accuracy of the value set as GYPSY LAP
F
affects the accuracy of the measurement of
the lowered chain.
If using the imperial system to measure the
gypsy turn, convert the measured value using the
following formula:
REFERENCE
ON THE CHAIN
BACKLIGHT ADJUSTMENT
Set the desired level
from 1 to 5 (default: 3).
GYPSY CIRCUMFERENCE
Enter the linear development value (in mm)
of the chain on the gypsy circumference
(default: 160 mm).
SENDING THE CONFIGURATION
Press the SEND button and position
the smartphone on the NFC area
of the SMART CHC.
Wait for confirmation of
NFC entry. The device will restart.
main axle.
bringing the mark back to the starting position.
the main axis and the point reached by the
mark after a complete rotation of the gypsy
(precision = 1 mm).
GYPSY LAP
(centimeters) = length (inches) × 2,54
(1)
Round the measurement obtained
(1)
to the first decimal place.
EN
21