AEG DBK8990HG Manual De Instrucciones página 36

36 www.aeg.com
It is recommended to leave
the hood operating for
approximately 15 minutes
after cooking.
The control Panel is a
sensor field. Touch the
symbols for 1 second to
activate the functions.
To operate the hood:
1. Turn on the appliance by pressing
the
You can now activate the functions.
2. To activate the function touch the
symbol.
3. If needed, touch the light symbol
to illuminate the cooking surface. To
change the light intensity touch and
hold the symbol again.
To turn off the appliance press the
symbol again.
3.2 Hob²Hood function
It is an automatic function which
connects the hob with a hood. Both the
hob and the hood have an infrared signal
communicator. Speed of the fan is
defined automatically on basis of mode
setting and temperature of the hottest
cookware on the hob. You can also
operate the fan using the hob manually.
The function can be activated from panel
of the hob.
For more information how to
use the function refer to the
hob user manual.
3.3 Activating Maximum
Motor Speed
When you touch
Motor Speed starts to operate for 8
Refreshes the air in kitchen after cooking at a very
low noise level. It can be activated and de-activated
by touching the symbol. The function turns off auto‐
matically after 60 minutes. Use after cooking only.
symbol.
, the Maximum
minutes. After that time, the appliance
returns to its previous speed settings.
When the function is turned
on, additional touch on
does not have any effects.
3.4 Filter notification
Filter alarm reminds to change or clean
the charcoal filter and clean the grease
filter. The filter indicator
for 30 seconds if the grease filter must
be cleaned. The filter indicator
for 30 seconds if the charcoal filter must
be replaced or cleaned.
Refer to cleaning the grease
filter in care and cleaning
chapter.
Refer to cleaning the
charcoal filter or replacing
the charcoal filter in care and
cleaning chapter.
To reset the function touch
seconds.
To activate or deactivate function:
1. Switch on the control panel.
2. Make sure that the icons are turned
white.
3. To activate function touch
seconds.
If the function is activated, the filter icon
flashes five times.
4. To deactivate function touch
seconds.
If the function is deactivated, the filter
icon flashes three times.
is turned on
flashes
for 3
for 3
for 3