Publicidad
Idiomas disponibles
Idiomas disponibles
Provozní pokyny
Provozní pokyny
Bezpečnostní pokyny
Warning / Important
• The tool together with any attachments or accessories, must never be used
for anything other than the designed purpose.
• All locally legislated safety rules regarding installation, operation and
maintenance shall be respected at all times.
• This product is only intended for industrial use and shall only be operated
indoor in dry rooms. This product must not be used in explosive
atmospheres.
• Only use power sockets.
• Keep hands, long hair and other objects away from the rotating socket.
• When using a suspension yoke, check that it is in good condition and
correctly fastened.
• Be prepared of the reaction force which will occur when the tool is used.
• Make sure that the tool is in good working order and that the controller is
correctly programmed before use to avoid unexpected behaviour from the
tool which may result in operator injury.
• ETD / ETP nutrunners are used together with a torque reaction bar. Please
be aware of the rotational direction of the spindle before starting the tool,
the reaction force may work in an unexpected direction with risk of crush
injuries.
• Never put your hand near or close to the reaction bar while the tool is being
used.
• Check function of the earth fault protector and ground loop continuity on
regular basis according instructions in the drive/ controller ASL.
• Always keep the POWER FOCUS/drive unit locked.
• Refer installation and servicing to qualified personnel only.
• Do not attempt to disassemble your Serial Port Adapter. Doing so will void
warranty. The product does not contain customer servicable or replaceable
components. Service should only be performed by Atlas Copco Tools AB.
• Hold power tool by insulated gripping surfaces, when performing an
operation where the fastener may contact hidden wiring. Fasteners
contacting a "live" wire may make exposed metal parts of the power
tool "live" and could give the operator an electric shock.
Battery tool use and care
• Recharge only with the charger specified by the manufacturer. A
charger that is suitable for one type of battery pack may create a risk of
fire when used with another battery pack.
• Use power tools only with specifically designated battery packs. Use of
any other battery packs may create a risk of injury and fire.
• When battery pack is not in use, keep it away from other metal objects,
like paper clips, coins, keys, nails, screws or other small metal objects,
that can make a connection from one terminal to another. Shorting the
battery terminals together may cause burns or a fire.
164
CS
© Atlas Copco Industrial Technique AB - 9836 899800 00
ETV STB63-70-13-IRC-W
Publicidad
