Descargar Imprimir esta página

GAF Master Flow GreenMachine PGSOLAR Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Safety Considerations and Warnings
1. Use appropriate safety glasses, gloves,
hard hats, restraints, and other equipment
to avoid injury.
2. Wear durable work gloves while handling the unit
during installation. This product has sharp edges
that can cause injury.
3. Observe all applicable building codes in your area.
4. Do not damage electrical wiring or other hidden
utilities when cutting or drilling.
5. Before servicing the unit, disconnect power leads from
solar panel to prevent accidental operation.
6. Make sure blade is on tight and ensure the set screw
is securely tightened.
Figure 1a
Figure
1b
MOUNTING
BRACKETS
Figure 4b
Figure 4c
V971247
7. Use this unit only in the manner intended by GAF.
If you have any questions, please contact Master Flow
Technical Services at 1-800-211-9612.
8. Ducted fans must always be vented to the outdoors.
Important: Your solar panel configuration may differ
slightly from the one shown in the illustrations. The
performance of all configurations is the same.
CAUTION: THIS UNIT IS FOR GENERAL VENTILATING
USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR
EXPLOSIVE MATERIALS OR VAPORS. THIS FAN HAS AN
UNGUARDED IMPELLER. DO NOT USE IN LOCATIONS
READILY ACCESSIBLE TO PEOPLE OR ANIMALS.
Figure 2a
NUT
BOLT
SHROUD
Figure 4d
INSTRUCTIONS
MODEL: PGSOLAR
Note: In the unlikely event that parts and/or
accessories are missing, or this product does not
®
operate correctly, contact Master Flow
Services at 1-800-211-9612 or WarrantyLLBP@gaf.com.
Do NOT return to retailers or distributors.
Tools Required
• Drill • Extension cord •
or adjustable wrench • Utility knife • Wood screws •
Power saber or jigsaw and handsaw • Safety eyewear
• Hard hat and other safety equipment • Fall-restraint
equipment • Caulking gun • ASTM D4586 Type 1 or 2
asphalt roofing cement or ASTM C920 urethane sealant
• Work gloves • Ladder • Phillips-head screwdriver
• Pencil or marker
Figure
2b
Figure 3
SOUTH
Figure 5a
Figure 5b
We protect what matters mos t
Technical
®
/
" Socket wrench •
/
" Socket
3
7
8
16
Figure 4a
Figure 6
MOTOR
EXHAUST SLATS
WIRE
CONNECTOR
WIRE TO
SOLAR PANEL

Publicidad

loading

Resumen de contenidos para GAF Master Flow GreenMachine PGSOLAR

  • Página 1 INSTRUCTIONS MODEL: PGSOLAR Safety Considerations and Warnings 7. Use this unit only in the manner intended by GAF. Note: In the unlikely event that parts and/or If you have any questions, please contact Master Flow accessories are missing, or this product does not 1.
  • Página 2 To visit gaf.com/ventcalculator to ensure the minimum the day (Figure 3). tilt the solar panel, loosen the two screws/nuts...
  • Página 3 INSTRUCCIONES MODELO: PGSOLAR Consideraciones de seguridad y advertencias 7. Use esta unidad solo de la manera que indica GAF. Nota: En el improbable caso de que las piezas y/o faltan Si tiene alguna duda, comuníquese con el servicio accesorios o este producto no funciona correctamente, 1.
  • Página 4 (Figura 5a) en el montaje de la guía o conexión. posible. Asegúrese de que el panel solar mire al sur para encuentra en la parte exterior del paquete o visita es.gaf. Luego levante el panel a la ubicación deseada y vuelva una potencia óptima.
  • Página 5 7. N’utilisez cet appareil que de la manière indiquée par Remarque : Dans le cas peu probable où des pièces GAF. Pour toute question, veuillez communiquer avec les et/ou il manque des accessoires ou ce produit ne 1. Utilisez des lunettes de sécurité, des gants, un casque Services techniques de Master Flow au 1-800-211-9612.
  • Página 6 à l’extérieur de l’emballage ou optimal. Vérifiez qu’il n’est pas à l’ombre d’un arbre ou position désirée et resserrez les vis (Figure 5b). visitez le site gaf.com/ventcalculator pour vous assurer d’autres structures avoisinantes durant le jour (Figure 3). que la ventilation d’arrivée d’air minimale recommandée Remarque : L’angle optimal du panneau solaire se calcule...