Publicidad
Idiomas disponibles
Idiomas disponibles
1
Ensure that the lter is operating and properly maintained. Turn the pump o .
2
Locate the Automatic Cleaner Line or the Pool Return under the water's surface. (For most
in-ground pools, there are multiple pool returns.) (Figure 1 – Automatic Cleaner Line or Pool
Return)
3
Securely screw the Flow-Control Fitting to the Pool Return/Automatic Cleaner Line, ensuring
that the Triangle Pressure Relief Hole is pointed toward the bottom of the pool. (Figure 2)
4
Turn the Flow-Control Collar to the OPEN position, where Triangle Pressure Relief Hole is not
covered by Flow-Control Collar. (Figure 2)
5
Connect the Elbow Fitting to the Flow-Control Fitting (Figure 3)
6
The Fountain Head should always be above the pool's surface. Choose between the 12" or 18"
Aluminum pipe depending upon the height needed for the fountain to easily clear the pool
surface. Secure to the Elbow Fitting and screw the Nut closed. (Figure 4)
7
Connect the Fountain Head to the other end of the Aluminum Pipe and secure the
Nut until tight.
8
Face the front of the Fountain Head toward the pool and ensure the Nut ttings are screwed
securely to both ends of Aluminum Pipe. It is normal if some leaking occurs in and around the
Fountain Head.
9
Turn on the pool pump and enjoy!
If the spray is too low or lights are not visible (at night), the water pressure /
ow is probably too low.
1
Slowly screw the Flow-Control Collar until the water spray is at desired height.
2
If the results are not satisfactory, insert a Rubber Plug or Plastic Threaded Cap into the other
pool returns until the water spray reaches desired height. The more inlets plugged, the higher
the fountain spray. NOTE: This step is not necessary when connected to pool cleaner inlet.
3
In above-ground pool, if the water pressure / ow is still too low after you've plugged
additional inlets, you may need a pump with more horsepower.
If the water spray is too high, reduce the water pressure / ow
Loosen the Flow-Control Collar until the Triangle Relief Hole is fully open. Height adjustment is
1
achieved by covering more or less of the Triangle Pressure Relief Hole on your Flow Control
Fitting. The more the triangle hole is covered, the higher the fountain spray and vice versa.
Open other returns in the pool, until water spray is at desired height.
2
PROBLEM
CAUSE
Fountain Too Low
a) Flow-Control Collar is opened too wide.
b) Not enough inlets plugged.
c) Dirty lter.
Fountain Too High
a) Triangle pressure release hole is
covered too much.
b) Too many inlets are plugged.
Note:
Check and clean lter screen on occasion
REMEDY
a) Screw in Flow-Control Collar so
triangle is covered more or completely.
b) Plug more inlets.
c) Backwash or clean lter unit.
a) Unscrew Flow-Control Collar so less
of triangle is covered.
b) Unplug more inlets.
Figure 1
Flow-Control Collar
Triangle Relief Hole
Figure 2
(Bottom View)
Figure 3
Figure 4
poolmaster.com
2
Publicidad
