Livoo DOM472 Manual De Instrucciones página 14

ON/OFF Button: Plug in the appliance, you will hear a sound, the indicator light will light
up, press the ON/OFF button, the appliance will start at the lowest speed and in normal
mode. Press the button again to switch the device to standby.
Speed Button: this button allows you to change the speed of the ventilation by linking
the 3 possible speeds: Low-Medium-High.
Wind button (MODE):
The normal mode is activated as soon as the device is switched on. If you press the
button again, you switch to the natural mode and the night mode. The indicator light for
the selected mode lights up. In nature mode, the fan speed changes randomly to
simulate the wind.
Cooler/humidifier button
When you press this button, the corresponding indicator light on the display lights up and
the unit emits humidified air. The temperature of the diffused air will be cooled according
to the temperature of the water in the unit. Press a second time to stop the function. This
function does not work if the water level is under "MIN".
Swing Button (OSC)
When you press this button, the oscillation function starts and the corresponding
indicator light on the display lights up. Only the outer grill of the appliance oscillates.
The two grids below the oscillating grid can be adjusted manually. Press a second time
to stop the oscillation.
Timer button
When you press this button, the appliance starts and indicator light corresponding to
the "1H" comes on. Press this button to select the desired operating time (maximum
time: 8H).
The display shows times that must be added up to obtain the total operating time
before the device goes into standby.
Cleaning and maintenance
Cut off the power and unplug appliance before cleaning
1. Clean the paper filter block :
Unscrew the two screws holding the rear panel to gain access to the filter. Once the rear panel is
removed, take the filter out of its housing and clean it with a soft brush. Important: To avoid any
leakage, gently replace the filter block.
2. Clean water tank:
Turn the water tank lock to the horizontal position and take out the tank to the maximum (about
1/3). Wipe the tank then replace it and turn the lock to the vertical position.
3. Clean the housing:
Wipe off the housing by neutral cleaner and soft cloth.
www.livoo.fr