LUND 67180 Manual De Instrucciones página 8

GB
APPLIANCE SPECIFICATION
The electric mop is used to clean hard surfaces with two rotating microfi bre pads. The mop works quickly and easily, thanks to the
battery power supply. The product is designed for domestic use only and may not be used in commercial applications. The correct,
reliable, and safe operation of the appliance depends on its proper use, therefore:
Read and keep the entire manual before the fi rst use of the appliance.
The supplier shall not be held liable for any damage resulting from failure to observe the safety regulations and recommendations
specifi ed in this manual.
ACCESSORIES
The mop is supplied with microfi bre pads and a battery charger.
SAFETY INSTRUCTIONS
CAUTION! Read all of the following instructions. Failure to do so may result in electrocution, fi re, or personal injury.
FOLLOW THE INSTRUCTIONS BELOW
Do not use the product in an explosive environment containing fl ammable liquids, gases, or vapours.
Do not place the appliance near any heat or fi re sources.
Connect the charger only to a power network supplying the voltage and frequency indicated on the appliance's nameplate. The
charger's plug must match the power socket. Do not modify the plug. Do not use any adapters to fi t the plug into the socket. Using
an unmodifi ed plug that matches the socket reduces the risk of electrocution. After each application, unplug the charger's plug
from the mains socket.
The appliance is intended for indoor use only. Do not expose the appliance to any precipitation or moisture. If water and moisture
enters the appliance, it will signifi cantly increase the risk of electric shock. Do not immerse the product in water or any other liquid.
Do not obstruct the vent holes and make sure they are clear. Obstructed and/or clogged vent holes may cause the appliance to
overheat. This can damage the appliance and cause fi re or electric shock.
Turn the appliance off , make sure the switch is set to the OFF position before changing, cleaning, or adjusting any part or accessory.
This appliance may be used by children of at least 8 years of age and by persons with reduced physical, mental abilities and
persons with no experience or knowledge of the appliance, if supervised or instructed on its safe use so that the risks associated
with it were understandable. Children should not play with the appliance. Children should not be allowed to clean or perform
maintenance activities on the appliance without supervision.
The appliance is intended for home use only.
Do not use the appliance to clean people or animals and do not bring the spinning pads close to fi ngers or other body parts.
The pads are intended for cleaning hard and smooth surfaces. Do not use them to clean carpets, carpet fl oorings, and similar
materials. This could destroy the pads or even the mop itself.
Do not clean cigarette butts, matches, or hot ash.
Do not clean fi ne dust, e.g. fl our, gypsum, printer toner, etc. Do not use the mop for cleaning industrial waste, e.g. sawdust, debris,
metal fi lings, etc.
APPLIANCE OPERATION
CAUTION! Turn off the appliance and make sure the power switch is in the OFF position, before carrying out any assembly and
disassembly of its accessories.
Appliance assembly and disassembly
Unpack all elements of the appliance and remove all packaging components.
Before fi rst use, the appliance must be properly assembled. It is possible to assemble the appliance in two confi gurations: short
or long (II). Mount the handle directly onto the head or using the extension (III). Please note that a smaller diameter connector
features a notch, which fi ts the tip of a larger diameter connector. The connectors are secured with a latch. When connecting,
press and hold the latch button lightly. When the latch has snapped into place, the latch button should protrude from the hole.
To disassemble the connector, press and hold the latch button and then separate the connection (IV).
The head features a special latch, which keeps the mop handle in a vertical position (V). This makes it easier to store the mop.
Before installing a microfi bre cap, dampen it with water and then squeeze out excess water (VI).
The microfi bre pads should be attached to the head discs (VII) with Velcro. Try to place the pads concentrically on the discs, so
that they do not come into contact with each other during rotation. The microfi bre side must be facing outwards. It will be easier to
ensure precise installation, if the cap is fi rst folded in half, attached to the head disc, and then unfolded, so that the entire surface
O R I G I N A L I N S T R U C T I O N S
8