Revel RB-1032 Manual página 41

7. To check the correctness of assembly, spin the blade a couple of times by hand. If the
blade moves freely and is not loose, you can start using the saw.
Cutting angle adjustment
Adjustment can be done in two angles. To change the angle: twist the locking lever, adjust
the angle, and twist the blocking lever back.
Switching on/off
The power tool has been equipped with the ON/OFF switch with lock what prevents
accidental starting. To turn on the device:
1. Press and hold the lock button.
2. While holding the lock button, press and hold the switch on/off button.
3. Release the ON/OFF switch to switch off the power tool.
Using the rip guide
Rip guide can be used to make a cut parallel to surface, that the rip guide is resting on. Slide
the rip guide into the rip guide holes, according to the picture below, and screw in the
security screw.
MAINTENANCE
Before cleaning and maintenance, always switch off the power tool and remove the
battery.
Clean the casing regularly with a soft cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and dirt. Clean the blade (remember about the
blade shaft) with a brush or compressed air. Remove very persistent dirt using a soft cloth
moistened with soapsuds. Do not use any solvents such as gasoline, alcohol, ammonia, etc.
Chemicals such as these will damage the synthetic components.
41 EN