Descargar Imprimir esta página

Mr Coffee BVMC-ECM171 Serie Guia Del Usuario página 15

Publicidad

Do not leave water in the water
reservoir between uses.
Make sure the frothing wand is
submerged in your milk or milk
substitute (Figure 21) before turning
the knob to steam.
Do not store portafilter in the brew
head. Remove portafilter after brewing. Leaving the
portafilter in the machine can cause an improper lock
which could result in leaking and damage to the seal.
Do not fill water to the top of the water reservoir.
This is a manual machine without auto shut-off. You
control how much espresso is brewed by turning the
control knob.
Cord storage is under the unit.
2% milk creates better froth than milk substitutes.
28
Problems, Causes and Solutions
Figure 21
Your Mr. Coffee® Steam Espresso, Cappuccino and Latte Maker
has been carefully designed to give you many years of trouble-
free service. In the unlikely event that your new espresso
machine does not operate satisfactorily, please review the
following potential problems and try the steps recommended
BEFORE you call Mr. Coffee Service Center.
Problem: Unable to steam
Possible Causes:
Solution:
Problem: Espresso does not come out
Possible Causes:
Water reservoir is empty
Unit is not turned on
Frothing wand is clogged
Fill water reservoir with 2 oz (the steam icon on the water
measuring pitcher) of water and pour into water reservoir.
Plug in power cord and slowly turn control knob to Steam position.
Remove frothing wand cover and check if metal frothing wand
is clogged with a needle or paper clip. Then, following cleaning
instructions on page 24.
No water in water reservoir
Coffee grind is too fine
Too much coffee in the filter
Appliance not turned on or plugged in
29

Publicidad

loading