Puqpress M2 Manual De Instrucciones página 20

5.2 Using the PUQpress
1. Level the grounded coffee in the port-a-
filter.
2. Insert the port-a-filter between the
upper and lower clamp.
3. The PUQpress automatically starts
tamping the coffee. The contactless
sensor detects the metal port-a-filter.
4. Wait until the PUQpress has tampered
the coffee.
5. Remove the port-a-filter after a full cycle
of approximately 1.3 seconds.
5.3 Adjusting the tamping force
Adjust the tamping force by using the display
and the buttons.
1. Press the up button to increase the
force.
2. Press the down button to decrease the
force.
NOTICE
The force is displayed in kilograms (kg) or
pounds (lbs).
5.4 Selecting the tamping mode
1. Press and hold the set button for 5
seconds.
2. Use the up and down button to adjust
the setting.
3. Choose between the following settings:
M2/M3/M5/M6
Code Setting
P0 SPEEDY
P1 PRECISE
P2 SOFT
P3 HULK
P4 SINGLE
Code Setting
P0 SPEEDY
P1 PRECISE
P2 SINGLE
4. Press the set button to confirm the
setting.
5.5 Checking the tamping cycle count
1. When the PUQpress is not in use, press
and hold the up and down button for 3
seconds.
2. The display flashes a number for 5
seconds. Multiply this number by 5,000
to get the tamping cycle count.
5.6 Checking the cleaning cycle count
1. Press the set button.
2. Press and hold the up and down button
for 3 seconds when the PUQpress is in
clean modus.
20
Explanation
Normal tamping speed
1.3 seconds
Slow retraction of the
tamper base
Slow retraction of the
tamper base, lower
tamping force (5 – 15
kg)
Triple tamp
Single tamp
M4
Explanation
Normal tamping speed
1.3 seconds
Slow retraction of the
tamper base
Single tamp