Publicidad
Idiomas disponibles
Idiomas disponibles
Methods of use
• First, open any one of the outlet valves at the outlet of the water heater, then,
open the inlet valve. The water heater gets filled with water. When water flows
out of the outlet pipe it implies that the geyser has been filled fully with and water,
the outlet valve can be closed.
Note: During normal operation, the inlet valve shall be always kept open.
lnsert the supply plug into the supply socket, and switch ON.
•
adjust the temperatura controller suitably .
The HEATING indicator will light up.
•
The temperatura controller will automatically control the temperature.
When the temperatura inside the heater has reached the set temperatura,
it will switch off automatically, when the water temperatura falls below
the set point the heater will be turned on automatically to restare the
heating. When the heater is switched off automatically, the heating indicator
will switch off.
6
Publicidad
