Publicidad
Idiomas disponibles
Idiomas disponibles
6. Clean and dry the mounting location with an alcohol pad
prior to mounting camera. Slide the camera into the mount
and secure it to the windshield using the pre-installed
adhesive pad on the mount (Fig. A). Be sure to mount the
dash cam behind the rear view mirror in a manner to not
obstruct the view of the driver while positioning the camera
lens as close to the center of the vehicle and as level as
possible. Connecting to the dash cam using the Thinkware
smartphone app may be necessary to fine tune the up and
down adjustment so that the picture is adequate.
7. Bundle and secure all left over cable (Fig. B).
Fig. B
9. With the vehicle's ignition in the OFF position and the IGN-3F plugged in, the LED should be emitting a slow consistent flash.
The LED will change from a flashing state to being ON solid once you start the vehicle. When the LED is ON solid, a phantom
ignition signal will be sent to the dash cam to turn it on and will remain on during the event of a start/stop sequence. The LED and
dash cam will turn off 2 minutes and 30 seconds after the vehicle is shut down.
10. Using the included wire tie, secure the module and the factory OBD II junction under the dash or kick panel in a way that will
not impact the airbags' ability to deploy in the event of an accident.
11. Ensure that any and all of the vehicles trim that may have been removed during the previous installation steps is reinstalled.
The following page is only needed when installing the secondary interior IR camera or the rear facing camera.
For assistance, please contact Echomaster at fordsupport@echomaster.com or call (866) 766-2267
Fig. D
Fig. A
8. With the vehicle's ignition in the OFF position, connect
the IGN-3F to the 10-Pin Molex connector located on the
HWK-TW01-HAR (Fig. C).
Fig. C
Page 3 of 4
Publicidad
