Energeeks EG-MODPERS001 Guía De Instalación Rápida página 26

First connect the brown power cable to the L, S1 (left terminal) and
S2 (right terminal) connections of the module. The three inputs are
230v current inputs, so you can supply all three from the same point
using a terminal.
The 2 phases that feed the motor for up or down direction, which
until now were powered by the blind switch, now you must connect
them to the outputs S1 (right terminal) and S2 (left terminal) of the
module. The cables of the blind switch must be connected to the K1
and K2 inputs of the module respectively.
Finally, connect the neutral of the 230v power supply (blue current
cable) to input N of the control module.
Make sure the installation has been done correctly according to the
connection diagram and restore power.
The module will start flashing rapidly, indicating that it is in
installation mode. If not, restart it (see device restart below).
26