Publicidad
Idiomas disponibles
Idiomas disponibles
FEATURES
USING THE CONTROL PANEL
START/STOP
Press once to start continuous running up to 12 minutes; press again to stop.
REVERSE
If the feed chute chamber becomes blocked or ingredients are not processing,
press and hold REVERSE. There will be a beep and a brief pause, then the auger
will rotate in the opposite direction. Release REVERSE to stop. Repeat as needed.
Press START/STOP to resume normal operation.
USING THE FILTERS FOR PULP CONTROL
Control the amount of pulp by choosing the appropriate filter.
LESS PULP
Use the Black
filter with the
finest mesh
for juice with
less pulp.
NOTE: For best results, we recommend using the Orange (Lots of Pulp) filter when processing soft fibrous fruits like
pears, berries, seeded melons, and pineapple.
To watch videos on how to use and clean
the Ninja NeverClog™ Cold Press Juicer,
scan the QR code.
ninjakitchen.com
USING THE JUICER
1
2
3
6 Place the pulp container under the pulp spout, then
LOTS OF PULP
Use the Orange
filter with the
largest mesh for
juice with lots
of pulp.
IMPORTANT:
• Review all warnings before proceeding.
• DO NOT add frozen fruits and vegetables or ice to the unit.
NOTE: If the feed chute chamber becomes blocked or ingredients are not processing, press and hold
REVERSE. There will be a beep and a brief pause, then the auger will rotate in the opposite direction.
Release REVERSE to stop. Repeat as needed. Press START/STOP to resume normal operation.
Plug in motor base and place on a clean, dry, level surface
such as a countertop or table.
Insert the auger into the feed chute chamber, then attach
the desired filter onto the auger, with the metal portion of
the filter on the bottom of the auger. The filter will sit
loosely around the auger.
Attach the pulp spout to the feed chute chamber
by installing at an angle on top of the filter, then
turning counterclockwise to lock in place.
4 Install the assembled feed chute chamber on the motor
5
place the juice jug under the anti-drip lever on the
feed chute chamber.
7
Select START/STOP, then gradually add ingredients to the feed chute.
For best results, allow juicer to process each ingredient before adding
more. Use the tamper to push ingredients down through the feed chute,
as needed.
8
When juicing is complete, select START/STOP, then close the anti-drip lever.
Stir juice and serve.
9 To disassemble, press and hold the RELEASE button while
turning the feed chute chamber clockwise and removing it
from motor base.
10 Remove the pulp spout from the feed chute chamber by
turning clockwise. Remove the filter and auger by gently
pulling them out of the feed chute chamber.
11 Unplug the unit when finished. If moving the unit, grab from
the bottom of the base. Refer to the Care & Maintenance
section for cleaning and storage instructions.
Align the metal
portion of the filter
with the bottom of
the auger.
base at an angle, then turn counterclockwise until it
clicks into place.
Install the food tray on the top of the feed chute chamber.
Make sure the
anti-drip lever is
open before juicing.
ninjakitchen.com
Publicidad
