KOOMANDO TM5886 Manual Del Usuario página 3

Control panel TM5886 e TM5895
for tubular motors and dampers
User's Manual Control Panel
CAUTION
If the unit is installed outdoors, it is advisable to disconnect the flat cable of the buttons.
III. ELECTRICAL CONNECTIONS
If the motor is controlled by pushbuttons or key selector (see Diagram 1), the connection must be modified so that the motor
cables are connected to the control unit without interruption (see Diagram 2).
Pushbuttons or
key selector
Diagram 1
Connections
L - N input line 220
EG fine-line-engine land
COM - ▲ - ▼ engine output
flashing light output 220V
or courtesy light
12V - GND output power photocells
DIP1
ON or OFF changes the
direction of movement of
the motor
Motor
- GND
+12 +12
DIP2
ON single button control
OFF 3 control keys
www.koomando.com - remote control store
I. TECHNICAL SPECIFICATIONS
1 Working Voltage: 85 - 265Vac
(110Vac 60Hz / 220VAC 50HZ)
2 Working temperature: -20ºC to + 60 ° C
3 Working time: 100s
4 Engine capacity: 1 HP (735W), 220Vac
or 0.5 HP, 110Vac
5 Integrated fuse: circuit (0.5A), motor (10A 250V)
6 Working frequency: 433.92MHz
7 Memorized remote controls max: 30
8 Size: 150x100x40 mm
9 Weight: 245 gr
10 IP56 protection
II. SAFETY INSTRUCTIONS
- Please read this manual before commissioning.
- Make sure the machine is not live before open the equipment
cover.
- Clear the memory before the commissioning of the unit
(ref. Erasing the memory).
- The signal can be disturbed by other communication devices.
- The unit must only be used for manual control and / or via radio
of geared motors for roller shutters.
The use for the control of high-risk systems.
- Each safety risk must be eliminated before use.
- If necessary, replace fuses with one of the same tics.
Control unit
Diagram 2
10-11 output 12 Vac supply to
photocells
13-14 connection NC photocell:
0 V
if not used, leave bridged
◄► - COM
▀ - COM
►◄ - COM
- COM
DIP3 (outputs 8-9)
ON flashing light
OFF fixed light
Pushbuttons or
key selector
Motor
N.C. photocells
input opening button (N.O.)
input stop button (N.O.)
input closing button (N.O.)
step by step button input
(OPEN - STOP-CLOSE- STOP ...)
DIP4
ON deadman
OFF semiautomatic
EN