Kesser K-Wave 3600 Manual De Instrucciones página 9

Operating instructions
1. Connect the clip to the battery:
Take the battery cable to connect the battery, connect the red-headed cable to the anode and the
black-headed cable to the cathode. Be careful not to short-circuit the anode and cathode. Do not
connect the wrong electrode.
2. Turn the handle to start. If you hear a "click", it means that you have engaged a gear. There are 5
forward gears and 3 reverse gears:
3. To adjust the motor, adjust the angle and depth under water:
Loosen this screw and
adjust the height of this
part to define the length
under water.
Do not tighten the
mounting bracket too
tightly so as not to
accidentally damage
the fiberglass shaft.
9
Reverse gear
Pointer
Insert the boat board into
the seat.
Forward gear
Velocity
Press here to release the spring,
then you can turn the shaft
around to adjust the angle of the
motor or take it out of the water.
After completing the setting,
release it, the motor remains in
the set direction.
Tighten these two screws
to attach the engine to
the boat