Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
Beyond replacing batteries and fuses, do not attempt to repair or service your Meter unless you are
qualified to do so and have the relevant calibration, performance test, and service instructions. The
recommended calibration cycle is 12 months.
Periodically wipe the case with a damp cloth and mild detergent. Do not use abrasives or solvents.
Dirt or moisture in the terminals can affect readings.
To clean the terminals:
a) Switch the Meter OFF and remove the test leads.
b) Shake out any dirt that may be in the terminals.
c) Soak a new swab with isopropyl alcohol and work around the inside of each input terminal.
d) Use a new swab to apply a light coat of fine machine oil to the inside of each terminal.
TEST LEADS REPLACEMENT
Warning
Full in compliance with safety standards can be guaranteed only if used with test leads supplied. If
necessary, they must be replaced with the same model or same electric ratings. Electric ratings of the test
leads: 600V/10A. You must replace the test leads if the lead is exposed.
The measurement category of a combination of the test leads and an accessory is the lower of the
measurement categories of the test leads and of the accessory.
The test leads intended for use within measurement category I, shall not to use the test leads for
measurements within the other measurement categories.
TESTING THE FUSES
WARNING
To avoid electric shock or injury, remove the test leads and any input signals before replacing the fuses.
1. Turn the rotary switch to 200mA position.
2. Use a multimeter to measure resistance of VΩmA terminal or 10A terminal to COM terminal.
A good mA terminal or 10A terminal fuse is indicated by a reading between 0Ω and 10Ω.
If the display is overloaded, replace the fuse and test again.
If the display shows any other value, have the meter serviced.
3. Please replace fuse as below:
Fuse 1: F10A / 600VH
Fuse 2: F0.5A / 600VH
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories
and packaging should be sorted, taken to a recycling centre and disposed of in a manner
which is compatible with the environment.
Disposal
Dispose of this product and the battery at the end of its working life in compliance with
the EU Directive on Waste Electrical and Electronic Equipment. When the product is no
longer required, it must be disposed of in an environmentally protective way. Contact
your local solid waste authority for recycling information or give the product for disposal
to BGS technic KG or to the dealer where you purchased the product.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
Publicidad
