Publicidad
Idiomas disponibles
Idiomas disponibles
When operating the electric lawnmower, you should
consider some precautions and operating procedures in
order to avoid accidents, damage and increase the
efficiency of the lawnmower:
▪ Always hold the lawnmower with both hands;
▪ When the power switch is not pressed, the blade does
not rotate. Otherwise, contact technical assistance to
carry out an inspection and solve the problem;
▪ If you hear an unusual noise or the lawnmower vibrates
abnormally, stop working and identify the cause;
▪ Never operate the lawnmower if it is damaged.
1. Plug the lawnmower into an extension cord;
2. To start operating the electric lawnmower, press the
safety switch (5) and then the power switch (6).
After having pressed the power switch, you can release the
safety switch.
To stop the lawnmower, simply release the power switch.
To adjust the cutting height, you just need to raise or lower
the wheel shafts.
The lawnmower features 3 cutting heights:
The lowest: 25mm.
The middle one: 45mm.
The highest: 65mm.
When the lawnmower is not running and before
performing
any
replacement tasks, unplug the power cord from the socket.
The electric lawnmower was designed to run for a long
period of time with minimal maintenance.
maintenance
or
accessories
▪ Regularly remove the grass and dirt that gets stuck to
the blade;
▪ Inspect the blade for damage, cracks, and excessive rust
or corrosion;
▪ A blunt blade can be sharpened, but a blade that is too
worn, bent, cracked or damaged must be replaced;
▪ Always check that the blade's fixing bolt is tight.
If you remove the blade to sharpen or replace it, wear
gloves.
1. Lay the machine on a vertical position;
2. Remove the bolt with the blade spanner provided. Use a
wrench securing the blade to prevent it from turning
when removing the bolt. Then remove the blade;
I
3.
nstall the blade using the bolt;
4. Tighten the bolt with the blade spanner. Use a wrench to
secure the blade to prevent it from spinning when
removing the bolt.
Cleaning
After each use clean all the components of the electric
lawnmower. Wipe the appliance with a clean, damp cloth
or blow with low pressure compressed air.
Remove all debris accumulated on the blade, with dry
compressed air at low pressure. Always wear safety goggles
when performing this operation.
Careful handling protects the appliance and extends its
service life.
Storage
The electric lawnmower must be stored in a dry place.
Publicidad
