Trisa electronics 9506.13 Manual Del Usuario página 42

9 Troubleshooting
PROBLEM
Brush roll not turning.
Water is not being dispensed.
Reduced suction power.
Water on the air outlet
Unusual noises during use.
Hard floor cleaner not working.
Can't switch to Max mode.
82
Instructions for use TRISA Hard Floor Cleaner
SOLUTION
Make sure the battery is charged. See 'Charging the
hard floor cleaner' .
Check if the brush roll is jammed. See 'Cleaning the
brush roll and vacuum tunnels' .
Make sure that the water tank is filled. See 'Filling
the water tank' .
Check if the water nozzle is blocked.
Make sure the battery is charged. See 'Charging the
hard floor cleaner' .
Check if the waste water tank is full. See 'Emptying
the waste water tank and catch bucket' .
Make sure that the brush roll is correctly installed.
Make sure the pipe tunnel is not clogged.
Check if the HEPA filter is mounted or damp.
Check if the waste water tank is full. See 'Emptying
the waste water tank and catch bucket' .
Check if the vacuum tunnel is clogged. See 'Cleaning
the brush roll and vacuum tunnels' .
Unusual noise can occur if the waste water tank is
empty.
Make sure that the battery is charged and correctly
installed. See 'Preparing the hard floor cleaner' .
Make sure that the hard floor cleaner is turned on.
Check if the brush roll is clean and correctly installed.
Check if the battery capacity is below 20%.
NOTICE Max mode is unavailable if the battery
capacity is below 20%.
PROBLEM
SOLUTION
Clean the brush roll.
Clean the HEPA filter and waste water tank.
Does not clean well.
Replace the HEPA filter if it has been in use for a
long time.
Replace the brush roll.
Instructions for use TRISA Hard Floor Cleaner
83