Publicidad
Idiomas disponibles
Idiomas disponibles
Explanation of the symbols on the equipment
m
Introduction
MANUFACTURER:
scheppach Fabrikation von
Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
We hope your new tool brings you much enjoyment and
success.
NOTE:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling,
• Noncompliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of nonoriginal spare
parts,
• Application other than specified
Unpacking
• Open the packaging and remove the device care
fully.
• Remove the packaging material as well as the pack
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, store the packaging until the warranty
period has expired.
ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
GB
Warning! Danger to life, risk of injury or damage to the tool are possible by ignoring!.
GB
Caution Read the operating instructions to reduce the risk of inquiry
Device Description (Fig.1-2)
1. Base frame
2. Foot rest
3. Foot 2x
4. Wheel 2x
5. Handle
6. Lever
A Wheel bolts M12x80 2x
B Circlip 4x
C Nut M 12 2x
D Nut M 12 2x
E Round head bolt M8x40 8x
F Nut M8 8x
G Carriage bolt M8x45 4x
H Nut M8 8x
I Circlip 8x, split washer 8x
J Fixing screws M6
K Round head bolt M8x65 4x
Safety Notes
•
•
•
•
•
•
•
•
•
Assemble the saw stand in the proper manner before
mounting the power tool. Proper assembly is impor
tant to prevent the risk of a collapse of the saw stand.
Attach the power tool securely to the saw stand be
fore using it. Slipping off of the power tool on the saw
stand can lead to loss of control.
Place the saw stand on a firm, level and horizontal
surface. If the saw stand can slip off or wobbles, the
power tool or the workpiece cannot be uniformly and
securely guided.
Do not overload the saw stand and do not use it as
a ladder or scaffolding. Overloading or standing on
the saw stand can lead to the upward shifting of the
centre of gravity of the stand and its tipping over.
When working or transporting, take care that all bolts
and connecting elements are firmly tightened. Loose
connections can lead to instability and inexact sawing.
Mount and dismount the power tool only when it is in
the transport position (for instructions on the transport
position, also see the operating instructions of the
respective power tool). Otherwise, the power tool can
have such an unfavourable centre of gravity that it
cannot be held securely.
When the power tool is mounted to the mounting
plate, operate it exclusively on the saw stand. Without
the saw stand, the mounting plate with the power tool
does not stand securely and can tip over.
Ensure that long and heavy workpieces do not affect
the equilibrium of the saw stand. Long and/or heavy
workpieces must be supported at the free end.
Keep your fingers clear of the hinge points while
pushing the saw stand together or pulling it apart.
9 І 56
Publicidad
