Car and Driver CAD-AIRX300 Manual Del Usuario página 3

2
Charging
2-1 Charging your inflator
Connect one end of the included Type C charging cable to the Type-C charging
port of the inflator. Then connect the other end to a USB power source. When
charging, the battery power indicator will flash on the LCD display screen.
Battery power indication on the LCD display screen
Battery Power Indication
2-2 Using the inflator to charge your devices
This inflator can also be used as a power bank to charge your electronic devices.
1. Press the Power button
battery power indicator on the display will be lit.
2. Directly connect the USB charging cable (USB-Lighting/USB-Micro USB/
USB-Type C charging cable) to the USB port of the inflator, and the other end
to the charging port of your device.
NOTE: If there is no use within 30 seconds of the power bank being turned on,
it will automatically turn off.
3
Powering on / off
To power on the inflator, press the Power button
display screen will turn on.
To power off the inflator, press the Power button
NOTE: If there is no use within 100 seconds of the inflator being powered on,
it will automatically power off.
Type C Charging cable
(Included)
once to turn the power bank on, and only the
M
USB Charging cable
Power Level
0~25%
25%~50%
50%~75%
75%~100%
(not included)
M
M
EN 2
NOTE: It takes about 3
hours to fully charge the
inflator.
for 1 second, and the
for 1 second again.