Publicidad
Idiomas disponibles
Idiomas disponibles
Input AC frequency
Output voltage
Output current
Output power
Average active efficiency
Efficiency at low load (10 %)
No-load power consumption
Use of the device
Charging the battery in your device (Figure 3)
Insert the tip of the adapter into the power connector on the bottom of the device. Then plug the adapter
into a power outlet. The charge indicator in the upper left corner of the display will light up (see Figure 4 -
A). If you start the fan, the charging process will be interrupted. The maximum continuous charging time
is 3.5 hours.
Fitting
To unfold the fan pull the orange button under the carrying handle (Figure 2) to release the fan mast.
Unfold the fan head and then raise the telescopic mast until it is locked in the vertical position. Extend
the mast by gently pulling upwards (from 49.5 to 90cm).
To fold the fan, retract the telescopic pole and fold the fan head. Pull the orange button under the
carrying handle (Figure 2) to release the mast. You can now move the unit with the carrying handle.
Operation
You can use the buttons on the remote control or the buttons on the base of the unit to operate the
unit (Figure 1).
Press the on/off button
display.
Press the speed button
Press the
button to start the oscillation. The corresponding LED on the screen will light up (see Figure
4-C). The fan oscillates from left to right with a 40° stroke (see Figure 2).
Press the
button to start the timer. The timer indicator lights up (see Figure 4 - D).
Select the desired running time by pressing this button (from 1 to 9 hours). At the end of the selected
time, the appliance will go into standby mode.
The button
in figure 1 on the remote control is used to start the nature mode. In nature mode, the unit
will simulate the generation of a random wind by varying the speed of the ventilation.
Cleaning and maintenance
Switch off and unplug the appliance before cleaning.
Remove the screw under the front grille of the fan. Then turn the grille clockwise and remove it (Figure 5).
Wipe the surface of the fan blades with a soft damp cloth.
. The unit will start with the default speed level 2. This level is shown on the
to select the desired speed (from 1 to 8).
www.livoo.fr
50-60
15.0
1.0
15.0
Hz
V
A
W
%
%
W
Publicidad
