Publicidad
Idiomas disponibles
Idiomas disponibles
a contact separation in all poles that provide a full disconnection. The
circuit breaker must have a contact opening distance of at least 3
mm.
The product is in class I and IP55, wich is the protection rate forthe
units to be used even outdoor. For keeping the protection rate of
the appliance, the connection of the appliance with the power sup-
ply must be done by means of a minimum IP55 system, as per the
standards HD 384 CENELEC for Europe, or international IEC 60364-7
1988.
Under no circumstances turn the appliance on if it is on any surface.
-
A safety distance of not less than 100 cm should always be left in
-
front of the heaters or too near.
The appliance must not be located neither directly below, nor in
-
front of a socket-outlet.
The heater must be installed so as to prevent that the switches can
-
be touched from those who are in the shower.
Avoid the use of an extension cord with this product, because the
-
extension cord may overheat and cause a risk of fire.
Ensure that there is no possibility of inflammable material, combus-
-
tible material or curtains coming into contact with the heater, or lie
near the heater.
All radiant heaters are designed to achieve and maintain a certain thermal
comfort for people. It is therefore very important to carefully study the
area where people stay and consequently direct the radiation towards
WARNING!
All irradiation heaters are designed to achieve and maintain a cer-
tain thermal comfort to the people who need it both outside and in-
side. It is therefore very important to carefully study the area where
people stay and consequently direct the radiation towards them.
them.
12
Publicidad
